Insane Vapor Launcher

1. Tilt Base
2. Gas fills from base of tank through water
3. Fine opening aluminum screen just above gas inflow
    (to decrease bubble size and help absorb moisture)
4. There are 19 zip ties on the Clark Release.
    (to reduce stretching)
5. About 1' of water will be loaded into the base of the tank.
     (for the bubbles to be diffused through and pick up moisture)
6. Smoothed transition from 3" tank to 1" launch tube.
7. Changed design eliminating cross bar which held launch rod to launcher.
    (this bar was creating turbulence and restricting air flow)
8. Total length of launcher is 16'.